Blog
Orca Slicer Support Interface Filament: Assign a Second Material
Assign a different filament to the support interface in Orca Slicer, see how the interface layers divide between the two materials at two or more layers, and check the stack in Preview before printing.
Latest
View all
OrcaSlicer Elephant Foot Compensation Layers: How the Offset Tapers
OrcaSlicer applies the full bottom-layer offset, then smaller offsets across the chosen layers. In the five-layer example, layer five still has 20%; zero starts on layer six.
OrcaSlicer Modifier Mesh vs Negative Part
In OrcaSlicer a modifier volume changes print settings inside its region while a negative part subtracts geometry. See how each type is added, why a volume can appear to do nothing, and what to check in Preview before printing.
Orca Slicer Precise Z Height: Match the Sliced Height to the Model
Precise Z Height changes the final layer heights so the wiki's 20.1 mm cube slices at 20.1 mm instead of 20.2 mm at 0.2 mm layers. How to enable and check it, and why that height is not a printed measurement.
OrcaSlicer Infill Wall Overlap: Find the Right Control
In Orca Slicer, Infill Wall Overlap enlarges sparse infill into the inner wall. See what the percentage is measured against, why 10-15% is only a starting band, and how to compare junctions without mixing up other overlap controls.
Orca Slicer Wall Order: Inner/Outer, Outer/Inner or Inner/Outer/Inner
Inner/Outer, Outer/Inner and Inner/Outer/Inner print the same loops in a different sequence. See what each order changes for overhangs, seams and outer finish, when Inner/Outer/Inner needs three walls, and how to compare them with one variable changed.
What Orca Slicer's Seam Gap Setting Changes at the Loop End
Orca Slicer's seam gap shortens the end of each wall loop. The percentage is measured against nozzle size, so 10% of a 0.4 mm nozzle is 0.04 mm, and it is tuned after pressure advance and extrusion checks.
How Avoid Crossing Walls and Max Detour Length Work in OrcaSlicer
Avoid Crossing Walls reroutes travel around printed perimeters, but OrcaSlicer's max detour limit applies to the extra distance rather than the whole route. See how the limit is read and checked in Preview.
Orca Slicer Only One Wall on Top Surfaces: What It Changes
Orca Slicer's Only one wall on top surfaces keeps a single perimeter on detected top faces and gives the top infill more room. See how to compare slices.
Orca Slicer Ensure Vertical Shell Thickness: Why Extra Solid Infill Appears
See what Orca Slicer's vertical shell thickness option adds near slopes, how None, Critical Only, Moderate and All differ, and how to check it in Preview.